Genie garage door intellicode keypad manual
Select a location to mount the Keypad at a minimum height of 5 feet (m) out of the reach of Children. 1 2Remove battery cover and battery. 3Mark the top mounting hole and drill 1/8 inch(mm) pilot hole. Install the top screw, allowing 1/8 inch (mm) to protrude above the surface. · In this video we show you how-to program your Genie Wireless Keypad to Genie Intellicode garage door openers. This model GK-R wireless keypad is compatible. This new Genie Intellicode Radio Receiver connects differently than previous versions of Genie external receivers. The receiver is powered through the terminals marked power and common. A Genie garage door opener which has only 3 terminals on its motor head will use the terminals on the motor head marked 1 for common and 3 for power.
Genie®'s Keyless Entry Intellicode® Remote is a keyless entry system for access to your garage without the need for a key. Intellicode®'s rolling code technology prevents unauthorized persons from opening your garage door by automatically changing the access code every time you use it. Shipping Dimensions: H x W x D. Genie's Wireless Garage Door Opener Keypad is an exterior access system for your garage without the need for a remote or a physical key. Compatible with all Intellicode® equipped Genie garage door openers. Auto-Seek Dual Frequency (/ MHz) provides strong, secure signals that minimize interference and improve performance. To Reset the Intellicode Wireless Keypad Open cover half way. Press and hold "PROG" and "8" while fully opening cover. Indicator light will blink once and go out. Close cover fully. To Program the Intellicode Wireless Keypad Open cover fully by sliding keypad cover up until it latches. Press Press "PROG". (red light blinks).
To Reset your Genie of Fairview Intellicode Wireless Keypad follow these steps. Open cover half way. Press and hold both the “PROG” and “8” keys and open the cover until it latches. (the indicator light on the keypad will blink one and go out) Close cover. Programming your Intellicode keypad. Open cover fully until it latches. Genie Garage Door Opener Wireless Keypad Model GPWK, GWK. (works with remotes having 9 or 12 internal code setting switches. Keypad is black with a slide-up cover showing the Genie logo only) This keyless garage door opener entry pad works with Genie transmitters using MHz frequency. It is NOT compatible with Genie Intellicode transmitters (if your keypad has Intellicode printed on the cover, go to the next set of programming instructions below). Open the Genie Intellicode keypad cover halfway. Press the PROG and 8 buttons simultaneously, and hold them down. The indicator light should blink once, alerting you that your wireless keypad is ready to be programmed. Keep the cover open, and enter 3, 5, and 7 on the keypad.
0コメント